Ethanol steam reforming for hydrogen generation over structured catalysts

E. LÓPEZ; N. DIVINS; A. ANZOLA; N. SCHBIB; D.O. BORIO; J. LLORCA

INTERNATIONAL JOURNAL OF HYDROGEN ENERGY

PERGAMON-ELSEVIER SCIENCE LTD

Lugar: Amsterdam; Año: 2013 vol. 38 p. 4418 - 4428

0360-3199

The present paper reports on the preparation, characterization and reaction evaluation of structured catalysts towards hydrogen generation via ethanol steam reforming. To these ends, 400 cpsi cordierite monoliths were functionalized with Rh-Pd/CeO2 catalyst. SEM, TEM and XRD showed a uniform and well-covering CeO2 layer where Rh-Pd nanoparticles of less than 0.5 nm were anchored. The functionalized monoliths were successfully tested for synthesis gas production from ethanol steam reforming. Realistic operating conditions were selected, including temperatures between 500 and 950K, pressures from 1 to 6 bar, undiluted ethanol:water molar ratios 1:4-1:8 (i.e., 2≤S/C≤4) and a wide range of feed loads. Appropriate activity and hydrogen selectivity were verified for the catalytic system, with ca. complete ethanol conversion at T>700K and a minor, or even negligible, generation of by-products (acetaldehyde, acetone, ethane, ethylene). Operating at 950K and 1.5 bar, a H2 yield of 3.4 mol hydrogen per mol ethanol in feed was achieved for a liquid feed load of 0.22E-3 mlliq/(mgcat.min) (S/C=3), with 8.1% of CH4 and 8.2% of CO on dry basis. Kinetic parameters of a phenomenological set of reaction rate equations were fitted against experimental data, considering ethanol decomposition (methane formation) with subsequent methane steam reforming to both CO and CO2 and water-gas shift reaction.