Plasma-CVD-coated glass beads as photocatalyst for water decontamination

KARCHES, MARTIN; MORSTEIN, MARCUS; RUDOLF VON ROHR, PHILIPP; POZZO, ROBERTO L.; GIOMBI, JOSÉ L.; BALTANÁS, MIGUEL A.

CATALYSIS TODAY

ELSEVIER SCIENCE BV

Año: 2002 vol. 72 p. 267 - 279

0920-5861

Amorphous TiO2 films were deposited on glass microbeads using a specially designed circulating fluidized bed plasma-CVD reactor. The film thickness was varied between 7 and 120nm. While only little carbon impurity was found, XPS analysis revealed the presence of silicon, sodium and alkaline earth elements in the titania coating. Reduced amounts of these substrate-originating impurities were observed in the thicker films. By ToF-SIMS imaging, cross-sectional TEM and time-resolved dissolution, the titania coatings were proven to be uniform, both per particle and in terms of the film thickness distribution. The photocatalytic performance of the composite particles was evaluated in a fully irradiated fluidized-bed photoreactor. The thinnest films had some photocatalytic activity in the as-deposited state, possibly induced by the high specific power of the microwave plasma or silicon doping. The thicker films needed a post-deposition calcination at 723 K to achieve catalytic activity. Both the degree of anatase crystallization and the activity were improved by applying thicker films and after UV irradiation-plus-calcining. All films showed good adhesion and abrasion resistance during the photocatalytic tests. The best plasma-CVD films were about 70% as efficient (per unit reactor volume) as the reference material, P-25 immobilized on quartz sand. © 2002 Elsevier Science B.V. All rights reserved.