Effect of zeolite matrix over products distribution of catalytic pyrolysis of biomass waste

C. FERMANELLI; L. PIERELLA; C. SAUX

Conferencia; VI San Luis Conference 2018; 2018

Thermo-chemical conversion of biomass has become a promising technology for fuel and platform molecules production. In Argentina, peanut (Arachis hipogaea) industry leaves about 200000 tons of biomass waste per year, all concentrated in the central area of the country causing serious environmental issues. Three types of zeolites, namely ZSM-11, Beta and Y have been tested by means of catalytic pyrolysis of biomass in order to evaluate the effect of the zeolite matrix over bio-oil yield and products selectivity.While ZSM-11 and Beta zeolites were obtained by the traditional hydrothermal crystallization method1,2 Y zeolite was commercially acquired from Sigma Aldrich. The formers, after synthesized and desilicated, were finally exchanged with NH4Cl solution, desorbed in N2 flow and further calcined at 500 °C to obtain the protonic forms. The last procedure also applied to Y zeolite. The catalysts were named H-ZSM-11, H-Beta and H-Y. Fresh and used materials were widely characterized.Peanut shells were washed, grinded and sieved to obtain particle size less than 3.35 mm (ASTM E-11/95). Grinding diminishes heat transfer problems associated with solids3.Pyrolysis reactions were done in a fixed bed reactor at 500 °C under 60 mL/min of N2 flow for 10 min. Condensable products were collected in a liquid trap submerged in a refrigerant bath and further analyzed and quantified by GC and GC/MS. Both catalytic and non-catalytic runs were performed for comparison purpose. Higher concentration of desired products namely, toluene, furfural, xylene, 5-hydroxymethyl furfural (5-HMF), and three methyl benzene (TMB), among others was observed when H-ZSM-11 catalyst was employed. Moreover, selectivity towards xylene and 5-HMF was 10% and 5% respectively, compared to the 1.5% reached when H-Beta zeolite was used and 0% with H-Y.In terms of product yields, while bio-char yield was similar in the three cases studied, bio-oil yield varied in the range of 30-50%. The maximum throughput was achieved with H-ZSM-11 zeolite and the minimum was observed when H-Y catalyst was the one utilized. Bio-gas yield was comparable in the cases of H-ZSM-11 and H-Beta (around 20%), but it was much higher with H-Y zeolite. The use of zeolites in biomass pyrolysis is beneficial for interesting chemical production, particularly H-ZSM-11 zeolite. This catalyst has proven to generate not only higher bio-oil yields than the others studied, but also a liquid with higher concentration of desired products.