Global bifurcation analysis of a controlled underactuated mechanical system

D. M. ALONSO; E. E. PAOLINI; J. L. MOIOLA

NONLINEAR DYNAMICS

Springer

Lugar: Dordrecht; Año: 2005 vol. 40 p. 205 - 225

0924-090X

In this paper, bifurcation theory is employed to classify different dynamical behaviors arising in an underactuated mechanical system subject to bounded controls. The methodology is applied to an inertia wheel pendulum consisting of a simple pendulum with a rotating disk at the end. Restricting the magnitude of the control action places an important obstacle to the design of a continuous controller capable of swinging-up and stabilize the pendulum at the inverted position: the arm only can reach that position by means of oscillations of increasing amplitude. The controller is derived from a simple nonlinear state-feedback law, followed by a saturating device that limits the maximum amplitude of the control action applied to the system. This bound gives birth to a rich dynamical behavior, including pitchfork and Hopf bifurcations of equilibria, saddle-node bifurcations of periodic orbits, homoclinic and heteroclinic bifurcations. The global dynamics is analyzed in terms of certain control gains and a two-parameter bifurcation diagram is derived. It is shown that the dynamics on this bifurcation diagram is organized in a pair of codimension-two rotationally symmetric bifurcation points. Finally, it is found out that when the control gains lie on a certain region in the parameter space simultaneous stabilization of the upright position together with a large basin of attraction is obtained. Simulation results show that almost global stabilization of the system can be achieved.