Dynamics of sonoluminescing bubbles within a liquid hammer device

URTEAGA, R.; GARCIA MARTINEZ, P.; BONETTO, F.J.

PHYSICAL REVIEW E - STATISTICAL PHYSICS, PLASMAS, FLUIDS AND RELATED INTERDISCIPLINARY TOPICS

American Physical Society

Año: 2009 p. 1 - 8

1063-651X

We studied the dynamics of a single sonoluminescing bubble (SBSL) in a liquid hammer device. In particular, we investigated the phosphoric acid–xenon system, in which pulses up to four orders of magnitude brighter than SBSL in water systems (about 1012 photons per pulse) have been previously reported [Chakravarty et al., Phys. Rev. E 69, 066317 (2004)]. We used stroboscopic photography and a Mie scattering technique in order to measure the radius evolution of the bubbles. Under adequate conditions we may position a bubble at the bottom of the tube (cavity) and a second bubble trapped at the middle of the tube (upper bubble). During its collapse, the cavity produces the compression of the liquid column. This compression drives impulsively the dynamics of the upper bubble. Our measurements reveal that the observed light emissions produced by the upper bubble are generated at its second collapse. We employed a simple numerical model to investigate the conditions that occur during the upper bubble collapse. We found good agreement between numerical and experimental values for the light intensity (fluence) and light pulse widths. Results from the model show that the light emission is increased mainly due to an increase in noble gas ambient radius and not because the maximum temperature increases. Even for the brightest pulses obtained (2×1013 photons, about 20  W of peak power) the maximum temperatures computed for the upper bubble are always lower than 20  000  K.