Weld line strength factors in a reinforced injection molded part: Relationship with predicted fiber orientation

QUINTANA, MARIA C; FRONTINI, PATRICIA

JOURNAL OF REINFORCED PLASTICS AND COMPOSITES

SAGE PUBLICATIONS LTD

Año: 2019

0731-6844

In this work, the residual strength of a fiber-reinforced injection molded part containing a hot weld line?or meld line?was evaluated. Injected plates were generated using a double-gated mold under four different process conditions. Quantification of the weld line detrimental effect was made in base on a fracture mechanics experiment. Specimens with and without the weld line?obtained from the same plates?were tested under a clamped single edge notched tension (SENT) configuration. For each set of process conditions, a relative weld line strength factor was defined in terms of the maximum applied stress intensity factor (KImax) as: KImax of specimens with weld line/KImax of specimens without weld line. In parallel, the fiber distribution pattern was obtained by process simulation software Moldex3D. An orientation factor was determined from simulation in order to quantify the effect of the local fiber orientation around the weld line. Optimal process condition and the most significant variable influencing the weld line strength were calculated via statistical analysis. Results showed a clear correlation between the weld line strenght factors and the orientaion factor. It was demonstrated that the fracture performance of the weld line region is controlled by the fiber orientation arrangement developed on that zone.