Composites from PMMA Modified Thermosets and Woodflour

B. A. ACHA; M. I. ARANGUREN; N. E. MARCOVICH; M.M. REBOREDO

POLYMER ENGINEERING AND SCIENCE

Wiley

Lugar: new York; Año: 2003 vol. 43 p. 999 - 1010

0032-3888

The mechanical behavior of composites made from woodflour and a modified thermoset unsaturated polyester resin has been examined. Polymethylmethacrylate (PMMA), a common low profile additive (LPA), was used as the matrix modifier. Woodflour, the reinforcing filler, was used “as received” and was also modified with a commercial alkenyl succinic anhydride (ASA), in order to enhance the compatibility with the resin. The composites exhibited higher flexural and compressive modulus and compressive yield stress than the neat resin, while flexural strength and ultimate strain were reduced. The addition of PMMA to the unfilled thermoset led to a LPA morphology and decreased the flexural modulus, but produced an increment in flexural strain at break, impact energy and toughness of the UP resin. No enhancement in the mechanical behavior of the composites was found when treated woodflour instead of unmodified woodflour was used.