Epoxy–Urethane Copolymers: Relation Between Morphology and Properties

P. M. STEFANI; S.M. MOSCHIAR; M.I. ARANGURE

JOURNAL OF APPLIED POLYMER SCIENCE

wiley

Año: 2001 vol. 82 p. 2544 - 2552

0021-8995

ABSTRACT: The modification of an amine-cured epoxy resin by the addition of polyurethanes (PU) was investigated, and their mechanical and impact properties were related to their microstructure and morphology. For the study, two different PUwere selected:a commercial sample, D12, with a NCO : OH ratio equal to 2 and end blocked by reaction with an alkylphenol; and a synthesized sample, with NCO : OH ratio equal to 1 and equally end blocked in our laboratory. The usual trend of improved toughening and reduced modulus, EF, and compression yield stress, sYC, was observed in all samples. However, the toughening of the D12-modified samples was larger for the same initial rubber content. This result correlates with a finer rubber particle separation, but also the ductilization effect that this rubber has on the epoxy-rich phase. D12 co-reacts with the epoxy–amine, leading to a lower glass transition temperature (Tg) of the modified system and incomplete phase separation, as observed by scanning electron microscopy. The practically unreactive PU1 rubber leads to the usual spherical inclusion morphology observed in modified epoxies, except at 20% rubber content. The particular morphology generated in this case, co-continuous epoxy-rich and rubber-rich regions, leads to a material with the largest toughening in this study, but also with an impressive reduction in mechanical properties.©2001 John Wiley&Sons, Inc. J Appl Polym  Sci 82: 2544–2552, 2001